Install or recover S3 WiFiCom on a LilyGO T-Display-S3 LCD from Chrome or Edge. Devices already running the OTA-capable release can update directly from Settings.
1. Confirm the hardware
This firmware is only for the LilyGO T-Display-S3 LCD. Do not install it on the older T-Display ESP32, AMOLED, Pro, or another ESP32-S3 board.
2. Choose a release channel
Checking release…
Build
—
Size
—
SHA-256
—
3. Choose the installation type
Hold BOOT while connecting USB, release it, then choose one option below. Reconnect USB or press Reset after installation finishes.
Fresh Install
Use for a new board or storage that cannot be loaded. This installs a clean FFat filesystem and permanently removes existing saves, downloaded sprite packs, wallpapers, and other files.
Data will be erased. Allow the browser's erase option when prompted.
Use Chrome or Edge on desktop or Android.HTTPS is required for browser flashing.
Firmware Recovery
Reinstalls the boot files and application without writing the 9.9 MB FFat partition. Existing saves, downloaded sprite packs, and wallpapers are preserved.
Do not erase the device if the browser offers an erase option.
Use Chrome or Edge on desktop or Android.HTTPS is required for browser flashing.